ASTM C653 Standard Guide for Determination of the Thermal Resistance of Low-Density Blanket-Type Mineral Fiber Insulation

ASTM C653 隔熱的礦物纖維塊材和板材標準規范

 

ASTM C 653描述了作為產品代表的特定密度和厚度的低密度毯式絕緣材料熱阻值的計算和插值。它要求該平均密度和厚度的測量值，以及由試驗方法C 177、C 518或C 1114確定的表觀導熱系數值。

 

本指南適用于礦物纖維材料的密度范圍約為6.4至48 kg/m3（0.4至3.0 lb/ft3）。它主要適用于低密度、礦物纖維質量的絕緣板條和毯子，不包括任何膜面。這些產品的表觀導熱系數數據通常在平均溫度23.9°C（75°F）和熱-冷板溫差27.8°C（50°F）或22.2°C（40°F）下報告。

Scope

This guide describes the calculation and interpolation of a thermal resistance value for low-density blanket-type insulation material at a particular density and thickness having been selected as representative of the product. It requires measured values of this average density and thickness, as well as apparent thermal conductivity values determined by either Test Method C 177, C 518, or C 1114.

This guide applies to a density range for mineral-fiber material of roughly 6.4 to 48 kg/m3 (0.4 to 3.0 lb/ft3). It is primarily intended to apply to low-density, mineral-fiber mass insulation batts and blankets, exclusive of any membrane facings. Apparent thermal conductivity data for these products are commonly reported at a mean temperature of 23.9°C (75°F) and a hot-to-cold plate temperature difference of 27.8°C (50°F) or 22.2°C (40°F).

 

ASTM C167 Test Methods for Thickness and Density of Blanket 

ASTM C168 Terminology Relating to Thermal Insulation

ASTM C518 Steady-State Thermal Transmission Properties 

ASTMC1045 Practice for Calculating Thermal Transmission Properties 

ASTM C1114 Steady-State Thermal Transmission Properties by Means of the Thin-Heater

ASTM C177 Steady-State Heat Flux Measurements and Thermal Transmission Properties