ASTM D6290塑料丸粒顏色測定的標準試驗方法—標準名稱

ASTM D6290 Standard Test Method for Color Determination of Plastic Pellets

ASTM D6290塑料丸粒顏色測定的標準試驗方法

ASTM D6290塑料丸粒顏色測定的標準試驗方法—適用范圍

Scope：

This test method is intended primarily for the instrumental measurement of the degree of yellowness (or change of degree of yellowness) under daylight illumination of homogeneous, nonfluorescent, nearly-colorless transparent or nearly-white translucent or opaque plastics. The measurement is made on pellets and based on tristimulus values obtained with a spectrophotometer or colorimeter.

ASTM D6290塑料丸粒顏色測定的標準試驗方法—引用文件

ASTM D883 Terminology Relating to Plastics

ASTM D2244 Practice for Calculation of Color Tolerances and Color Differences from Instrumentally Measured Color Coordinates

ASTM E179 Guide for Selection of Geometric Conditions for Measurement of Reflection and Transmission Properties of Materials

ASTM E284 Terminology of Appearance

ASTM E308 Practice for Computing the Colors ofObjects by Using the CIE System

ASTM E313 Practice for Calculating Yellowness and Whiteness Indices from Instrumentally Measured Color Coordinates

ASTM E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

ASTM E1331 Test Method for Reflectance Factor and Color by Spectrophotometry Using Hemispherical Geometry

ASTM E1347 Test Method for Color and Color-Difference Measurement by Tristimulus Colorimetry

ASTM E1349 Test Method for Reflectance Factor and Color by Spectrophotometry Using Bidirectional (45°:0° or 0°:45°) Geometry
 

詳情請咨詢：中科易朔防火技術服務有限公司

出自GF2022